Related Topics
RIPng Commands
Fireware uses the Quagga routing software suite v0.99.18, which supports most routing commands available in more recent versions of Quagga. For more information about Quagga commands, see Quagga Routing Suite Documentation.
To create or modify a routing configuration file, you must use the correct routing commands. This list includes some of the supported routing commands that you can use in a RIPng configuration. The sections must appear in the configuration file in the same order they appear in this list.
| Section | Command | Description |
|---|---|---|
| Configure interfaces | ||
| no ipv6 ripng split-horizon | Disable split-horizon; enabled by default | |
| Configure RIPng routing daemon | ||
| router ripng | Enable RIPng | |
| Configure interfaces and networks | ||
| network eth[N] | Enable RIPng on the specified interface | |
| network [A:B:C:D:E:F:G:H/M] | Enable RIPng on the specified network | |
| passive-interface eth[N] | Set the specified interface to passive mode | |
| Distribute routes to RIPng peers and inject OSPF or BGP routes to RIPng routing table | ||
| route [A:B:C:D:E:F:G:H/M] | Enable RIPng static route announcements for the specified IPv6 network | |
| distribute-list [ACCESS-LIST] (in|out) eth[N] | Enable RIPng to use the specified access list to filter the RIPng path for the specified interface. The parameter in or out specifies whether the access list applies to incoming or outgoing packets on the specified interface. | |
| distribute-list prefix [PREFIX-LIST] (in|out) eth[N] | Enable RIPng to use the specified prefix list to filter the RIPng path. The parameter in or out specifies whether the prefix list applies to incoming or outgoing packets on the specified interface. | |
| default-information originate | Share route of last resort (default route) with RIPng peers | |
| default-metric <METRIC> | Set the default metric value for redistributed routes. The metric must be an integer from 1 to 16. | |
| redistribute static | Redistribute firewall static routes to RIPng peers | |
| redistribute static route-map [MAPNAME] | Redistribute static routes, with a route map filter (mapname) | |
| redistribute connected | Redistribute routes from all interfaces to RIPng peers | |
| redistribute connected route-map [MAPNAME] | Redistribute routes from all interfaces to RIPng peers, with a route map filter (mapname) | |
| redistribute ospf6 | Redistribute routes from OSPFv3 to RIPng | |
| redistribute ospf6 route-map [MAPNAME] | Redistribute routes from OSPFv3 to RIPng, with a route map filter (mapname) | |
| redistribute bgp | Redistribute routes from BGP to RIPng | |
| redistribute bgp route-map [MAPNAME] | Redistribute routes from BGP to RIPng, with a route map filter (mapname) | |
| Configure route redistribution filters with route maps and access lists | ||
| ipv6 access-list [ACCESS-LIST] [PERMIT|DENY] [A,B,C,D/M | ANY] | Create an access list to allow or deny redistribution of only one IP address or for all IP addresses | |
| ipv6 prefix-list [PREFIX-LIST] [PERMIT|DENY] [A,B,C,D/M | ANY] | Create a prefix list with a name | |
| route-map [MAPNAME] permit [N] | Create a route map with a name and allow with a priority of N | |
| match interface eth[N] | Match the specified interface | |